wlan bridge n

Enables bridging of the CTM Gateway wifi Acess Point (AP) with the LAN interface(s). When bridging is enabled (default), wifi clients will be on the same subnet as the LAN0 interface. Note that if LAN bridging is also enabled (cmd lanbridge 1), wifi clients will be on the same subnet as both the LAN0/LAN1 interfaces. When bridging is disabled, the wifi WLAN interface will be on a separate subnet (default 192.168.0.1/24).

Notes:

• This feature must be disabled when enabling half-bridge mode via cmd modemmode 1

Example:

1. disable bridging on wifi AP interface :
   cmd wlan bridge 0

See also: WLAN