swipe report r1 [r2] [r3] [r4] [r5] [r6] [r7] [r8]

This command sets the report(s) to be used for swipe card reader triggered reports.

r = 1 to 999

report number

Note:

When swipe report is configured to use a report, it appends to the already existing messages configured in the report a modified 114 message. The appended message contains the ID of the swipe card detected by the swipe card reader. mode must be configured correctly to allow the swipe card reader to communicate with the modem.

Examples:

uses report 2 with store and forward enabled for swipe card reader triggered reports, adds a standard message 114 as a message :
cmd repaddmes 2 114
cmd swipe report 2

report output:

$PGPS,171134.00,A,4915.3868,N,12259.8049,W,000.0,000.0,170609,+00004,5,09604890958*4A
$PGPS,171134.00,A,4915.3868,N,12259.8049,W,000.0,000.0,170609,+00004,5,09604890958,039-30391,V*33

In the above example the first line is the default 114? message, the second line shows the appended swipe card ID information added to the message. Note, the message type 114? does not have to be explicitly added as a message, this is handled automatically by the swipe report command.