snfdelay t sqi

This command sets the store-and-forward delay time and minimum signal strength (SQI) required before stored messages are forwarded.

t = 1 to 65535	Delay time in seconds (Default 20)
sqi	Magnitude of SQI threshold (Default 33)

Notes:

Valid SQI threshold should be a value between 0 and 60
SQI magnitudes greater than 60 or are negative will be set to the default SQI value (ie. 33 SQI). This is to support legacy command configuration.
message forwarding may not occur exactly at the snfdelay interval specified, and stored messages will only start forwarding when network conditions are deemed acceptable.

Examples:

Set the delay time before forwarding SNF data to 60 seconds with signal strength >= 40 SQI :
cmd snfdelay 60 40

Firmware revision 2.0.5.3581

Note: For CTM200R1 firmware use:

This command sets the store-and-forward delay time and minimum signal strength (RSSI) required before stored messages are forwarded.

t = 1 to 65535	Delay time in seconds (default 20)
rssi	rssi threshold (default -95)

Notes:

Valid RSSI threshold should be a value between -95 and 0
message forwarding may not occur exactly at the snfdelay interval specified, and stored messages will only start forwarding when network conditions are deemed acceptable.

Examples:

Set the delay time before forwarding SNF data to 60 seconds with signal strength >= -80 dBm :
cmd snfdelay 60 -80