pwr vcct vv.v t

Controls the supply voltage below which the CTM-200 gateway will automatically go into standby mode.

vv.v = 6.0 to 25.5threshold supply voltage at which the gateway will go into shutdown (default 9.0, typical for 12V battery operation)
t = 10 to 255duration of time in seconds that the supply voltage is below the threshold voltage before gateway enters shutdown (default 10)

Examples:

  1. Set the threshold to 20.0 volts with 10 seconds delay – this may be appropriate for a 24 volt battery :
    cmd pwr vcct 20.0 10

See also: Power Management


Firmware revision 2.0.1.2221

Last modified 7 years ago Last modified on 12-12-26 04:22:48 PM