pwr mode n
Controls the CTM-200’s power mode.
| n = 1 | puts the gateway in standby mode
|
| n = 2 | will power cycle the gateway immediately
|
Notes:
- cmd pwr mode 1 will output ERROR if a valid pwr woe command has not been set.
- If using SMS commands to control/configure the CTM-200, cmd pwr mode 2 should only be issued via SMS on devices running r2.0.4.2540 or later.
Example:
- power cycle the CTM-200 gateway :
cmd pwr mode 2
- place CTM-200 into standby mode :
cmd pwr mode 1
See also: General