pendantreport r1 [r2] [r3] [r4] [r5] [r6] [r7] [r8]

This command sets the general report(s) to be used for pendant triggered reports. Pendant reports are triggered by any message received from the Pendant including ON and OFF messages.

Up to 8 reports can be assigned to the pendantreport.

Notes:

• this command requires the modem to be listening for traffic from the WPAN gateway, this requires cmd mode 10 to be configured if using external WPAN gateway
• Pendant report is triggered by any message received from the Pendant. The following message is appended to the report:
  

$PPEN,ID,SEQ,MES*CHKSUM
ID - 64 bit unique hex ID of Pendant
SEQ - Packet sequence number
MES - Pendant message payload
CHKSUM - NMEA message checksum

Example:

$PPEN,0013A200402CB498,17,PANIC*07

Examples:

1. Use report 1 for pendant triggered reports :
   cmd pendantreport 1

See also: Man Down Pendant, General Reports

The format of this command has changed from R1.2.0 to R1.2.1. R1.2.0 allowed a single report, whereas up to 8 reports can now be configured.