panicreport r1 [r2] [r3] [r4] [r5] [r6] [r7] [r8]

This command will set the report(s) to be used for pendant triggered panic reports (PANIC and MPANIC only)

Notes:

• this command requires the modem to be listening for traffic from the WPAN gateway, this requires cmd mode 10 to be configured if using external WPAN gateway
• this command does not support server ACK mode and reptype 8 and 9
• Panic report is triggered by a panic message received from the Pendant. The following message is appended to the report:
  

$PPEN,ID,SEQ,MES*CHKSUM
ID - 64 bit unique hex ID of Pendant
SEQ - Packet sequence number
MES - Pendant panic message payload (PANIC or MPANIC)
CHKSUM - NMEA message checksum

Example:

$PPEN,0013A200402CB498,17,PANIC*07

Examples:

1. Use report 1 for pendant panic triggered reports :
   cmd panicreport 1

See also: Man Down Pendant, General Reports

Firmware revision 1.3.0.1727