ipsec split n
Enable/disable IPsec split-tunneling on the CTM-200.
n = 0 | disable split-tunnel
|
n = 1 | enable split-tunnel (default)
|
Notes:
- when split-tunnel is disabled, ALL outgoing traffic from the CTM-200 will be routed through the IPsec tunnel.
- when split-tunnel is disabled, ONLY ONE remote subnet should be defined. ie. cmd ipsec remnet 2..10 should all be 0.0.0.0 0.
- when split-tunnel is disabled A PC on the remote side of the tunnel will not be able to access PC/devices on the LAN side of the CTM-200.
- when split-tunnel is disabled, the CTM-200 cannot access PC/devices on the LAN side of the CTM-200.
Examples:
- Disable split-tunneling on the CTM-200 IPsec:
cmd ipsec split 0
See also: IPsec
Firmware revision 2.0.5.3034