ipsec natt n

Enable IPsec NAT traversal (NAT-T) setting. NAT-T allows one or both peers to reside behind a NAT gateway (i.e. doing address- or port-translation).

n = 0 Disable IPsec NAT-T setting (default)
n = 1 Enable IPsec NAT-T setting
n = 2 NAT-T is used regardless if a NAT is detected between the peers or not.

Examples:

  1. Set the IPsec NAT-T setting as enabled :
    cmd ipsec natt 1

See also: IPsec

Firmware revision 1.3.0.1994

Last modified 6 years ago Last modified on 14-05-01 09:04:30 AM