ignreport [n] [r1] [r2] [r3] [r4] [r5] [r6] [r7] [r8]

This command sets the report(s) to be used for ignition triggered reports.
Up to 8 ignition triggers can be configured, each supporting up to 8 reports.

n = 1 to 8	ignition trigger condition
r1 to r8 = 1 to 999	report number

Notes:

When sending ignition reports remotely, ignition reports will be stored on the CTM-200 until a signal is obtained. For the stored reports to be sent, the following conditions must be met:
- the CTM-200 must obtain a signal
- (Only applies to firmware below 3041) The same report number(s)(r1 to r8) used in this command must be used in another command (ie. obdreport, vccreport)
- (Only applies to firmware below 3041) The 'other' command (ie. obdreport, vccreport) must be sending live data

Examples:

Set report #2 and #5 for ignition trigger condition #1 :
cmd ignreport 1 2 5