idle cond n a b c

Set the Idle reporting and reset condition.

n = 1 to 8	idle condition number
a = 0	idle START trigger disabled (default)
a = 1	idle START trigger enabled, idle event will be triggered when idle > idle time
b = 0	idle END trigger disabled, idle event triggers when vehicle leaves idle state (default)
b = 1	idle END trigger enabled, idle event triggers when vehicle leaves idle state
c = 0	idle time accumulates, reset is via "cmd idle reset"
c = 1	idle time is reset at b=1
c = 2	idle time is reset at a=1 (state of b is ignored)

Examples:

cmd idle time 300 : Set idle time to 5 mins. Used in all following examples

Idle event will trigger twice. When idle time > 5 minutes AND when vehicle leaves idle state (ie starts moving) at which time idle will be reset :
cmd idle cond 1 1 1 1
Idle event will trigger twice. When idle when idle time > 5 minutes AND when vehicle leaves idle state (ie, starts moving). Total idle time will NOT be reset :
cmd idle cond 1 1 1 0
Idle event will trigger once, when idle > idle time. When vehicle leaves idle, no event is generated, cumulative idle is reset :
cmd idle cond 1 1 0 2
INVALID case. Idle event will NOT trigger. Total idle time will NOT be reset :
cmd idle cond 1 0 1 2
Idle event will trigger once, when vehicle leaves idle, cumulative idle is reset after event :
cmd idle cond 1 0 1 1
Idle event will trigger once, when idle > idle time, cumulative idle is reset after event :
cmd idle cond 1 1 0 1