fuel rate i d t
Sets whether timer or distance or both triggers when fuel rate is calculated. Whenever d or t triggers a calculation, both triggers are reset.
| i = 0 | Disable ignition based reset (Default)
|
| i = 1 | Enable ignition based reset
|
| d = 0 to 65535 | Delta distance in km to trigger fuel rate calculation (Default 1)
|
| t = 0 to 65535 | Delta time in seconds to trigger fuel rate calculation (Default 60)
|
Notes:
- Fuel rate is calculated by taking the difference between two total fuel readings obtained at different times based on an incrementing odometer "delta" value and factoring it to a L/100Km value.
- Fuel rate calculation requires active data from a connected OBDII/J1939/GPS/GPIO interface and fuel mode to be configured.
Examples:
- Configure the fuel rate to be calculated based on a "delta" odometer value of 25 km :
cmd fuel rate 0 25 0
- Configure the fuel rate to be calculated every minute :
cmd fuel rate 0 0 60
- Configure the fuel rate to be reset after each ignition ON and calculate fuel rate after every 60 seconds :
cmd fuel rate 1 0 60
- Configure the fuel rate to be reset after each IGN ON and to calculate fuel rate every 60s or every 100km, whichever is reached first :
cmd fuel rate 1 100 60
See also: Fuel Rate
Firmware revision 2.0.4.2690