aux report r1 [r2] [r3] [r4] [r5] [r6] [r7] [r8]

This command sets the report(s) to be used for auxiliary interface triggered reports.

r1 to r8 = 0	Disables the report (Default)
r1 to r8 = 1 to 999	Report number

Notes:

When aux report is configured to use a report, it appends a modified message 114, $PGPS? to the already existing messages configured in the report. The appended message contains the frame data received on the serial port at the end of the default $PGPS message.

Examples:

Configure auxiliary interface triggered reports to use general report 1 :
cmd aux report 1 0 0 0 0 0 0 0