multiwan mode m

Set multiwan mode type. Multiwan mode types can be used to configure special packet routing configurations.

m = 0	none (default)
m = 1	wi-fi traffic on lan0 ethernet, cell traffic on lan1 ethernet
m = 2	wi-fi traffic on lan1 ethernet, cell traffic on lan0 ethernet

Notes:

multiwan modes 1 or 2 can only be used with a dual-mode cell/wi-fi client configuration (cmd wlan enable 1)
lan bridging (cmd lanbridge) must not be enabled when using multiwan modes 1 or 2

Examples:

Enable multiwan so that all traffic on lan0 port uses wi-fi client interface :
cmd wlan enable 1
cmd multiwan enable 1
cmd multiwan mode 1