agpspde ip port tm pc pl nl

This command is used to configure Assisted GPS (A-GPS) parameters on supported wireless data cards/modules.

The cellular device chipset contains a GPS receiver. Position Determine Equipment (PDE) assists the cellular device to speed up satellite acquisition, the PDE sends satellite almanac and ephemeris information to the device.

ip = 0.0.0.0 to 255.255.255.255	IP address for location processing (Default 216.198.139.92)
port = 0 to 65535	Port number for location processing (Default 8889)
tm = 0	Transport mechanism is TCP/IP (Default)
tm = 1	Transport mechanism is Data Burst
pc	Position calculation type, fix type
pc = 1	Standalone
pc = 2	MS-based only
pc = 3	MS-assisted only = A-GPS Only (Default)
pc = 4	Optimum speed
pc = 5	Optimum accuracy
pc = 6	Optimum data
pl	Privacy level for location processing
pl = 0	Low (Default)
pl = 1	Medium
pl = 2	High
nl	Network access level for location processing
nl = 0	Network access only
nl = 1	No network access
nl = 2	Network access with demodulation (Default)
nl = 3	Network access without demodulation

Notes:

This feature currently works only on later model Sierra Wireless data devices that support A-GPS (USB598, USB597).
When a later model Sierra Wireless data device is used with a modem configured in half bridge mode, A-GPS support is not available and must be disabled.
A-GPS is disabled by cmd agpspde 0.0.0.0 0 0 1 0 1

Examples:

Set A-GPS parameters :
cmd agpspde 124.105.114.86 5412 0 3 0 2

Disable A-GPS feature :
cmd agpspde 0.0.0.0 0 0 1 0 1

Firmware revision 1.2.2 (rev 1531)